Table of Contents
Advertisement
To Enable Siren Activation upon Telephone Line Failure
1.
Make sure the system is disarmed and then press the
repeatedly until the PowerMax10-G2 display reads "INSTALLER MODE".
2.
When the PowerMax10-G2 display reads [INSTALLER MODE], press
The screen will now prompt you to enter your installer code.
3.
Enter your Installer Code.
4.
Press the
option.
5.
When the PowerMax10-G2 display reads [DEFINE PANEL], press
The PowerMax10-G2 display will read [01:ENTRY DELAY 1].
6.
When the PowerMax10-G2 display reads [01:ENTRY DELAY 1], press the
or
LINE].
Press
and make the selection and then press
7.
I
OK
The PowerMax10-G2 display will revert to [27:SIREN ON LINE].
You can now press the
"
" or press the
DEFINE PANEL
4.6 Event Reporting Configuration
4.6.1 General
The PowerMax10-G2 system uses an IP platform that supports GSM and GPRS cellular communication and broadband to
forward all events received at the control panel to the monitoring station.
4.6.2 Setup Report Communicators
4.6.2.1 Configuring PSTN / GSM Communicators
1.
Make sure the system is disarmed and then press the
repeatedly until the PowerMax10-G2 display reads "INSTALLER MODE".
2.
When the PowerMax10-G2 display reads [INSTALLER MODE], press
The screen will now prompt you to enter your installer code.
3.
Enter your Installer Code.
4.
Press the
display reads [DEFINE COMM.] option.
5.
When the PowerMax10-G2 display reads [DEFINE COMM.], press
The PowerMax10-G2 display will read [1:PSTN/GSM]
6.
When the PowerMax10-G2 display reads [1:PSTN/GSM] press the
button.
The PowerMax10-G2 display will read [AREA CODE].
Enter the system tel. area code (up to 4 digits).
7.
D-302756
or
button repeatedly and select the [DEFINE PANEL]
button repeatedly until the display will read [27:SIREN ON
or
button to take you to "
or
button repeatedly until the PowerMax10-G2
to confirm.
I
OK
button to program any other menu in
<OK> TO EXIT
button
.
I
OK
I
OK
".
button
.
I
OK
.
I
OK
I
OK
READY 00:00
INSTALLER MODE
I
OK
ENTER CODE:
CODE
or
DEFINE PANEL
I
OK
01:ENTRY DELAY 1
or
27:SIREN ON LINE
I
OK
SELECT OPTION
I
OK
27:SIREN ON LINE
READY 00:00
INSTALLER MODE
I
OK
ENTER CODE:
CODE
or
DEFINE COMM.
I
OK
1:PSTN/GSM
I
OK
AREA CODE
TEL. AREA CODE
21
Advertisement
Table of Contents
