Simrad ES70 - REFERENCE MANUAL REV A Reference Manual page 95

Supported telegram formats for distance
• RMC Recommended minimum specific GNSS data on page 193
• VHW Water speed and heading on page 194
• VTG Course over ground & ground speed on page 194
Supported telegram formats for positioning
• GLL Geographical position latitude/longitude on page 191
• GGA Global positioning system fix data on page 191
• RMC Recommended minimum specific GNSS data on page 193
Supported telegram formats for speed
• RMC Recommended minimum specific GNSS data on page 193
• VHW Water speed and heading on page 194
• VTG Course over ground & ground speed on page 194
Wiring procedure for serial communication
1 Locate a free RS-232 serial port that can be used to connect the navigation receiver.
2 On the ES70 computer, connect the receive signal
On the GPS system, wire as described in the relevant documentation.
3
Ensure that the length of the cable does not exceed approximately 50 meters. If a
4
longer cable is required, you may need to use buffer amplifiers on the serial line.
Setup procedure
Click the icon under the
1
Setup
2 Click
Navigation
3 For each tab:
a Select which port to use.
b Click
Setup
c Select which
If you choose Auto, the ES70 will automatically choose among the incoming
information according to a predefined priority list.
d If applicable, define the
4 Click to save the current settings and close the dialog.
OK
338106/A
menu to open the
Main
to open the
Navigation
for the selected port to define the communication parameters.
to use.
NMEA Sentence
Talker ID
on pin 2, and
Rx
Setup
dialog.
.
Operational procedures
on pin 5.
ground
sub-menu.
93