Simrad ES70 - REFERENCE MANUAL REV A Reference Manual page 64

Simrad ES70
•
Echograms
– How to select echogram presentation on page 70
– How to establish horizontal markers on page 71
– How to establish vertical markers on page 72
– How to select TVG gain on page 73
– How to remove interference and vessel's own noise from the echograms on page 74
– How to easier identify the bottom on page 74
•
Range
– How to choose the vertical range on page 75
– How to choose the start range on page 75
•
Bottom detection
– How to define maximum and minimum depth on page 76
•
Size distribution, biomass and fish density
– How to monitor the fish size distribution on page 77
– How to adjust the fish length for correct calculations on page 78
– How to monitor the current biomass on page 78
•
Gain
– How to adjust the signal gain on page 79
– How to adjust the TVG gain on page 80
•
Power and pulse duration
– How to choose passive mode on page 81
– How to change the output power on page 81
– How to adjust the pulse duration on page 82
•
Installation
– How to install a frequency channel on page 82
– How to disconnect a frequency channel on page 83
– How to modify an IP address on page 84
– How to install and upgrade the software on page 85
•
External interfaces
– How to set up the Ethernet output interface on page 88
– How to set up the Simrad ITI Trawl system interface on page 89
– How to set up the Simrad PI Catch monitoring system interface on page 90
– How to set up the sonar system interface on page 91
– How to set up the navigation system interface on page 92
– How to set up the motion sensor interface on page 94
– How to set up the depth output on page 95
– How to set up the annotation interface on page 96
62
338106/A