Software License - Simrad ES70 - REFERENCE MANUAL REV A Reference Manual

Simrad ES70
•
Change IP Address
The transceivers are provided by Simrad readily set up with a fixed Ethernet address
and an IP address. If your ES70 uses two transceivers with identical frequencies, these
will by default have different Ethernet addresses, but identical IP addresses. In order
for your system to work, all transceivers must have unique IP addresses.
The button opens the
→ How to modify an IP address on page 84
• : This is the type of transceiver currently selected on the channel list.
Type
means General Purpose Transceiver.
GPT
• : This is the identification of the transceiver currently selected on the channel
Version
list.
• : This is the software version running on the transceiver currently selected
SW Version
on the channel list.
• : This is the Ethernet address of the transceiver.
Ethernet Address
This address is fixed, and it can not be changed.
• : This is the IP address of the transceiver currently selected on the channel
IP Address
list.
If you use more than one transceiver with the same frequency, you must set up these
transceivers to provide different IP addresses.
•
Connected IP Address
to the transceiver.
Normally, this is the IP address of your computer.
• : This parameter identifies if the selected frequency channel is currently
Available
available for use with the ES70. If it is available, the status is identified as True.

Software License

The
Software License
sub-menu. The
Installation
Purpose
The purpose of the
Software License
strings) to unlock ES70 functionality. In order to obtain the license codes required,
contact your dealer.
156
: Use this feature to change the IP address on the transceiver.
dialog to accept the new address.
IP Address
: This is the IP address of the computer currently connected
dialog is opened from the
sub-menu is in turn found on the
dialog is to allow you to enter license codes (text
button on the
Software License
menu.
Setup
Installation
338106/A