How To Choose Operational Mode; How To Check The Transceiver And Transducer Settings - Simrad ES70 - REFERENCE MANUAL REV A Reference Manual

Simrad ES70
6 Check the echogram settings
Check the range settings
7

How to choose operational mode

1 Observe the
Main
Click the
2
Operation
3 Click the
Operation

How to check the transceiver and transducer settings

Observe that the currently connected transducer(s) are shown as tabs on the
1
Each transducer name also identifies the operational frequency.
Click the
2
Setup
→ Setup menu on page 108
3 On the menu, click
Setup
Observe that the
control the communication between the ES70 computer and the transceiver(s) and
transducer(s).
→ Transceiver Installation on page 153
4 Check that all applicable transceivers and transducers are connected and operational.
For each transceiver, this is indicated by the green label with text "Installed".
5 Click to save the settings and close the dialog.
OK
Click the
6
Operation
→ Operation menu on page 106
7 On the
Operation
22
menu on the right hand side of the ES70 presentation.
menu icon to open the
button, and select Normal.
icon to open the
Setup
Installation
Transceiver Installation
icon to open the
menu, click
Normal Operation
menu.
Operation
menu.
, and then
Transceiver Installation
dialog opens. This dialog is used to
menu.
Operation
.
.
Taskbar
.
338106/A