Simrad ES70
5
Observe that the sub-menu is closed, and that all text in the menu buttons change to
the selected language.
The context sensitive on-line help file may also be available in your language. To
change the language in the on-line help, restart the ES70. If your language is not
offered, the English on-line help will appear.
How to choose operational mode
This procedure explains how to set up the ES70 for normal operation.
Observe the
1
Main
presentation.
2
Click the
Operation
→ Operation menu on page 104
Click the
3
Operation
How to check the transceiver and transducer settings
This procedure explains how you can verify that the transceiver and transducer settings
are correct.
1
Observe that the currently connected transducer(s) are shown as tabs on the
Each transducer name also identifies the operational frequency.
Click the
icon under the
2
Setup
→ Setup menu on page 106
3
Click
Installation
On the sub-menu, click
dialog.
This dialog is used to control the communication between the ES70 computer and
the transceiver(s) and transducer(s).
Check that all applicable transceivers and transducers are connected and operational.
4
For each transceiver, this is indicated by the green label with text "Installed".
If a problem exists, refer to the relevant procedure in the Operational procedures
chapter.
24
menu. It is normally located on the right hand side of the ES70
icon under the
Main
button, and select Normal.
menu to open the
Main
to open the
Installation
Transceiver Installation
menu to open the
Operation
menu.
Setup
sub-menu.
to open the
Transceiver Installation
sub-menu.
.
Taskbar
343539/B