I Scan Resume Condition; Priority Watch - Icom IC-2820H Instruction Manual

7
SCAN OPERATION

I Scan resume condition

The scan resume condition can be selected as timer or
pause scan. The selected resume condition is also used for
priority watch. (p. ??)
The display shows that the scan will resume 15
sec. after it stops.
q Push [MAIN•BAND] to select the desired band (left or
right) as the main band.
w Push [F F •
] to display the function guide.
e Push [V/MHz•SCAN] (Right band's) to enter MENU
screen.
e Rotate the [DIAL] to select the
[MAIN•BAND].
r Rotate the [DIAL] to select the
[MAIN•BAND].
r Rotate the [DIAL] to set the desired timer:
• "T-5" : Scan pauses 5 sec. while receiving a signal.
• "T-10" : Scan pauses 10 sec. while receiving a signal.
• "T-15" : Scan pauses 15 sec. while receiving a signal.
• "P-2" : Scan pauses until the signal disappears and then re-
sumes 2 sec. later.
t Push [F F •
] to exit MENU mode.
55
SCAN mode, then push
" "
SCAN TIMER , then push
" "
z Push [BAND] to select the desired band (left or
SET
right) as the main band.
B
x Push [
B(D-OFF)] to enter set mode.
SET
c Push [
B(D-OFF)] or [
SET
times until "SCt" or "SCP" appears as shown at
left.
v Push [Y] or [Z] to select the scan resume condi-
tion.
• See item r at left for scan resume condition details.
b Push [
A(MW)] to exit set mode.
CLR
C(T-OFF)] several
ENT