Scan Resume Condition - Icom IC-E80D Instruction Manual

10
SCAN OPERATION

Scan resume condition

D Scan pause timer
The scan pauses when receiving signals according to the
scan pause time. It can be set from 2 to 20 sec. or unlimited.
q Enter "PAUSE" in SCAN set mode.
MENU SCAN
(Push [MENU
w Push [ ](2) or [ ](8) to select the desired scan pausing
time from 2–20 sec. (2 sec. steps) or "HOLD."
• "2SEC"–"20SEC" : Scan pauses for 2–20 sec. while receiving a
• "HOLD"
e Push [ ](5) to return to SCAN set mode.
r Push [MENU
110
PAUSE (p. 121)
]), (Push [ ](2)/[ ](8), then push [ ](5).)
signal.
: Scan pauses on a received a signal until it
disappears.
] to return to the frequency screen.
D Scan resume timer
The scan restarts after the signal disappears according to the
resume time. It can be set from 0–5 sec. or unlimited.
q Enter "RESUME" in SCAN set mode.
MENU SCAN RESUME (p. 122)
(Push [MENU ]), (Push [ ](2)/[ ](8), then push [ ](5).)
w Push [ ](2) or [ ](8) to select the desired scan resume
time from 0–5 sec. (1 sec. steps) and "HOLD."
• "0SEC" : Scan restarts immediately after the signal dis-
appears.
• "1SEC"–"5SEC" : Scan restarts 1–5 sec. after the signal disap-
pears.
• "HOLD" : Scan remains paused on the received signal
according to the scan pause timer even if it dis-
appears. Rotate [DIAL] to resume manually.
e Push [ ](5) to return to SCAN set mode.
r Push [MENU
] to return to the frequency screen.
Scan resume timer must be set shorter than the scan
pause timer, otherwise this timer does not activate.