D Scan Resume Condition; Open Scan - Icom IC-41W Instruction Manual

6
SCAN
D Scan Resume Condition
The scan resume condition can be set as a pause (P5) or
timer scan (15/10/5). When a signal disappears, scanning will
resume after 5 seconds, regardless of the setting.
Push and hold [Top] for 2 seconds to enter set mode.
q
Push [Top] several times until 'S-TIME' is displayed.
w
Push [CH Up] or [CH Down] to select the scan resume
e
time.
15/10/5 : Scan pauses for 15/10 or 5 seconds when a sig-
nal is detected, then resumes.
P5 : Scan pauses until the signal disappears, and
then resumes after 5 seconds.
r Rotate [VOL] to turn power OFF, or push and hold [Top] for
2 seconds to exit set mode.
Scan stop timer
P5 (default)
18
■
The open scan function scans for transmitted signals, making
it easier to locate new stations for contact or listening pur-
poses.
To start an open scan:
q
w Push
10 sec. setting
e
r Push

Open Scan

Push a few times until open scan is selected
• " " is displayed.
Appears
Open scan is selected.
to start the scan.
When a signal is received, the scan will pause and resume
according to the selected scan resume condition.
to cancel the scan.
Blinks
Scan start channel