Default Restore-File; Default Vlan Id - TRENDnet TL2-G244 User Manual

24-Port Gigabit Layer 2 Switch w/ 4 Shared Mini-GBIC Slots
Command History

default restore-file

Command
Syntax Description
Default Settings
Command Modes
User Guidelines
Example
Command History
Note

default vlan id

Command
Syntax Description
Default Settings
Command Modes
Example
Command History
12-6
Version History
1.00.001 This command was introduced.
To configure the default restoration file.
default restore-file <filename>
The name of restoration file.
filename
Iss.conf
Global Configuration Mode
This command is to configure the default restoration file.
switch(config)# default restore-file restore1.conf
Version History
1.00.001 This command was introduced.
Default mode must be dynamic to make this command effective.
To configure the default VLAN ID.
default vlan id <count(1-4094)>
Change default VLAN from 1 to 4094.
count(1-4094)
1
Global Configuration Mode
switch(config)#default vlan id 100
Version History
1.00.001 This command was introduced.