Cist Settings - TRENDnet TL2-G244 User Manual

24-Port Gigabit Layer 2 Switch w/ 4 Shared Mini-GBIC Slots
Forward Delay
Transmit Hold Count
Hello Time

CIST Settings

This page is to configure the port related MSTP settings.
Parameter
Select
Port
Path Cost
Priority
Point to Point Status
Edge Port
MSTP Status
Protocol Migration
Hello Time
AutoEdge Status
Restricted Role
6-10
is 20.
Specify the time period in second that a port changes the STP state from
blocking to forwarding. The possible value is 4-30. Default is 15.
Specify the hold counter to limit maximum transmission rate of the Switch.
Default is 3.
Specify the time interval in second for a root bridge broadcasts the hello
packets to other switches. Possible value is 1-2. Default is 2.
Figure 40 – Layer2 Management > MSTP > Port Configuration
Description
Select a port to apply the configuration changes.
Port ID.
Specify the path cost of the port. Possible value is 0-200000000. Default
200000000
Specify the spanning tree port priority. Possible value is 0-240. Default is 128.
Specify the link type of this port. ForceTrue means link type is point to point;
ForceFalse means it is shared; Auto means the decision will made
automatically. Default is auto.
Specify if this port is edge port or not. Select True to enable the portfast
function, False to disable it. Default is false.
To enable or disable the MSTP on this port. Select Enable to enable MSTP on
this port, Disable to disable it. Default is enabled.
To control if the port will migrate among MSTP, RSTP and STP automatically if
another switch runs different protocol. Select True to enable the protocol
migration function, False to disable it. Default is False.
Specify the hello time of this port. Possible value is 1-2. Default is 2.
To enable or disable the auto edge detection of this port. Select True to
enable the auto edge function, False to disable it. Default true.
To enable or disable the root guard function to prevent the port becoming a