Snmp-Server Enable Traps; Snmp-Server Trap Udp-Port - TRENDnet TL2-G244 User Manual

24-Port Gigabit Layer 2 Switch w/ 4 Shared Mini-GBIC Slots

snmp-server enable traps

Command
Syntax Description
Default Settings
Command Modes
Example
Command History

snmp-server trap udp-port

Command
Syntax Description
Default Settings
Command Modes
Example
17-9
To enable specific SNMP trap message types, and no form disable them.
snmp-server enable traps {firewall-limit | linkup | linkdown
| sip-states |sip-cfg-change
dhcp-pool-limit | dsx1-line}
no snmp-server enable traps {firewall-limit | linkup | linkdown|
sip-states | sip-cfg-change
dhcp-pool-limit | dsx1-line}
firewall-limit
linkup
linkdown
sip-states
sip-cfg-change
coldstart
poe-power
dhcp-pool-limit
dsx1-line
Linkup and Linkdown messages are enabled
Global Configuration Mode
switch(config)# snmp enable traps poe-power
Version History
1.00.001 This command was introduced
To specify the UDP port for sending SNMP trap messages
snmp-server trap udp-port <port>
no snmp-server trap udp-port
<port>
162
Global Configuration Mode
switch(config)# snmp-server trap udp-port 10162
|
|
Interfaces are linked up
Interfaces are linked down
The change of SIP protocol state
The change of SIP configuration
The switch is power cycled
UDP port number
coldstart | poe-power
coldstart | poe-power
|
|