Rmon Event - TRENDnet TL2-G244 User Manual

24-Port Gigabit Layer 2 Switch w/ 4 Shared Mini-GBIC Slots
Syntax Description
Command Modes
User Guidelines
Example
Command History

rmon event

Command
Syntax Description
41-2
number (1-65535)
mib-object-id (255)
sample-interval-time
(1-2147482647)
absolute
delta
rising-threshold
value (0-2147483647)
rising-event-number
(1-65535)
falling-threshold
value (0-2147483647)
falling-event-number
(1-65535)
owner ownername (127)
Global Configuration Mode
1. RMON function must be enabled and RMON event must be configured before
configuring alarms.
2. Using no form to delete a RMON alarm on a MIB object.
switch(config)#
1.3.6.1.2.1.17.7.1.3.1.1.3.141.0.0.0.0.0.22.0
rising-threshold 15 1 falling-threshold 10 1
Version History
1.00.001 This command was introduced
To add an event to RMON event table.
rmon event <number (1-65535)> [description <event-description
(127)>] [log] [owner <ownername (127)>] [trap <community
(127)>]
no rmon event <number (1-65535)>
number (1-65535)
description
event-description (127)
log
owner ownername (127)
trap community (127)
Specify the alarm number.
The MIB OID to set alarm.
The time interval in seconds that alarm monitors
the MIB variable.
To test the MIB variable directly.
To test the change between samples of a MIB
variable.
The threshold value to trigger alarm when the
number of sample exceeds.
The number of event to trigger when rising
threshold is exceeded.
The threshold value to reset alarm when the
number of sample exceeds.
The number of event to trigger when falling
threshold is exceeded.
Specify the owner of the alarm.
rmon
Specify the event number.
Setting the description of the event.
Generating syslog when event is triggered.
Specify the owner of the event.
Generating a trap message when event is
triggered.
alarm
10 delta
1