802.1X Timer Configuration - TRENDnet TL2-G244 User Manual

24-Port Gigabit Layer 2 Switch w/ 4 Shared Mini-GBIC Slots
Select
Port
Port Control
Auth PortStatus
Authentication Mode
Configured Control
Direction
Operational Control
Direction
AuthSM State
Restart Authentication
Authentication Retry
Count
Reauth
Click Apply to submit the changes.
Click 1-12, 13-24 to configure 802.1X port settings for corresponding ports.

802.1X Timer Configuration

This page is to configure the 802.1X timers of the device.
Parameter
6-19
Select a port to apply the configuration changes.
Port ID.
To set the authenticator control on this port. The possible options are:
ForceUnauthorized - All traffic is blocked to the port.
Auto - Enable the 802.1X authentication on this port, and the port authorized
or unauthorized will based on the 802.1X authentication result.
ForceAuthorized - All traffic is transparent to the port.
Default is ForceAuthorized.
Current authentication status of this port.
The authentication mode of this port. Only Port-based mode is supported
currently.
To choose the authentication control direction on this port.
In - Authentication control is only for ingress packets.
Both - Authentication control is for both ingress and egress packets.
Default is Both.
The current authentication direction on this port.
The current authentication state of this port.
To enable periodic re-authentication on this port.
To set the maximum 802.1X Extensible Authentication Protocol (EAP) retries
of the client before restarting authentication process.
To enable or disable the authentication retry function. Default is Disabled.
Figure 56 – Layer2 Management > 802.1X > Timers
Description