Channel-Group; Lacp Port-Priority - TRENDnet TL2-G244 User Manual

24-Port Gigabit Layer 2 Switch w/ 4 Shared Mini-GBIC Slots
Command History

channel-group

Command
Syntax Description
Command Modes
User Guidelines
Example
Command History

lacp port-priority

Command
Syntax Description
Default Settings
Command Modes
30-3
Version History
1.00.001 This command was introduced
To join a port to a channel group.
channel-group <channel-group-number(1-65535)> mode {active |
passive | on}
no channel-group
channel-group-n
umber(1-65535)
mode active
mode passive
mode on
Interface Configuration Mode
1. Port-channel group must be crested before assign port to a channel group.
2. The MTU of the port and channel group must be the same.
switch(config-if)# channel-group 1 mode active
Version History
1.00.001 This command was introduced
To set the LACP port priority of a port.
lacp port-priority <0-65535>
no lacp port-priority
Specify the port priority of the port.
0-65535
128
Interface Configuration Mode
Specify which channel group to configure.
Activates the LACP negotiation.
LACP negotiation starts only when LACP packet is
received.
Disables the LACP
aggregation.
negotiation, using manual