System Log Configuration; Sntp; Sntp And Current Time Settings - TRENDnet TL2-G244 User Manual

24-Port Gigabit Layer 2 Switch w/ 4 Shared Mini-GBIC Slots

System Log Configuration

This page is to configure system log settings.
Parameter
Syslog Status
Time Stamp
Messages Buffered
Size (1-200)
Syslog Server IP
Mail Server IP
Receiver Email
Address
Sender Email Address
Facility
Logging Level
Click Apply to submit the changes.

SNTP

SNTP and Current Time Settings

This page is to configure SNTP and time settings.
5-9
Figure 22 – System > System Log
Description
The status of syslog server function. Default is enabled.
Specifies if time stamp is attached with syslog messages. Default is enabled.
The size of internal logging buffer. Default is 50.
IP address of the external syslog server
Specify the IP address of mail server to be used for sending the email alerts
messages.
The email address of receiver that receives the alert messages.
The email address of sender that sends out the alert messages.
Specifies the facility that is indicated in the message. Possible values: local0,
local1, local2, local3, local4, local5, local6, and local7. Default is Local0.
Specifies the severity level of messages. Possible values are:
Alert level: action must be taken immediately.
Critical level: Critical conditions.
Debug level: Debug messages.
Emergency level: System is unusable.
Error level: Error conditions.
Informational level: Informational messages.
Notification level: Normal but significant condition.
Warning level: Warning conditions.
Default is info.