24-Port Gigabit Layer 2 Switch w/ 4 Shared Mini-GBIC Slots
Parameter
Restore Option
File Name
Click Apply to submit the changes and the Reset button will clear the information.
Erase Configuration
This page is used to reset the startup configuration, NV-RAM or the configuration file in flash to default value.
Parameter
Erase option
5-12
Description
Options to restore the startup configuration:
No Restore: Applying this option will reset the NV-RAM to default settings.
Note: This will only reset the settings in NV-RAM, not the entire device
configuration. After rebooting, only the default parameters in NV-RAM will be
reset to defaults. Requires a manual device reboot for changes to take effect.
Please reference the default NV-RAM parameters below.
•
Default IP Address : 192.168.10.200
•
Default Subnet Mask: 255.255.255.0
•
Default IP Address Config Mode: Manual
•
Default IP Address Allocation Protocol : DHCP
•
Default Interface Name: Fa0/1
•
Default RM Interface Name: NONE
•
Config Restore Option: No restore
•
Config Save Option: Startup save
•
Config Save IP Address: 0.0.0.0
•
Config Save Filename: iss.conf
•
Config Restore Filename: iss.conf
•
PIM Mode: Sparse Mode
•
IGS Forwarding Mode: MAC based
•
CLI Serial Console: Yes
•
SNMP EngineID: 80.00.08.1c.04.46.53
•
SNMP Engine Boots: 1
•
Default VLAN Identifier: 1
Flash Restore: Restore from a previously backed up configuration file in the
device's flash memory to the startup-config. Note: After restoring
configuration, requires a manual device reboot for changes to take effect.
Specify the file name of the configuration to be restored.
Figure 27 – System > Configuration > Erase
Description
Specify the configuration to be reset:
Erase Nvram: Reset the NV-RAM to default settings and reset all previously
saved configuration files to default that were stored flash memory.
Note: This will only reset the settings in NV-RAM, not the entire device
configuration. After rebooting, only the default parameters in NV-RAM will be
reset to defaults. Requires a manual device reboot for changes to take effect.