Setting Average; Setting Differentiation - Omron ZS-HL User Manual

Setting AVERAGE

The average of the measured values obtained based on the preset number of samples
can be output. Select this setting when you want to ignore sudden changes in measured
values.
FUN Mode-[FILTER]-[AVERAGE]
Setting
1, 2, 4, 8, 16, 32, 64, 128, 256, 512,
1024, 2048, 4096
(When the mode is set to High-
Speed mode, the value is from 1 to
256.)

Setting Differentiation

Use the differentiation function to detect only sudden changes in the measured values that
occur during very short periods of time.
The differentiation function detects changes between the present value and the measured
value that is in effect just before the comparing pitch. The coefficient of this comparing
pitch is defined as the differentiation cycle.
Example: Differentiation cycle=10 ms
Present value
Sampling
Sampling cycle
Display value
(differentiation result)
FUN Mode-[FILTER]-[DIFF]
Setting
OFF
ON
Sets the average count. (default value: 128)
The differentiation function is not used. (default value)
Sets the cycle (ms) in which to perform differentiation.
Range: 1 to 500
Setting the Filter Function
Description
Comparison interval 10 ms
Description
Section5
ZS-HL
5-13
User's Manual