Setting Flow - Omron ZS-HL User Manual

Section 1

Setting Flow

Setting Flow
Installation & Connection
Attach a Sensor Head according to the front side
material of the workpiece and the features of the Sensor.
Selecting the Status of Head Installation
Select either regular reflection or diffuse reflection.
Selecting Measurement Mode
Change it when the received light amount is small or when you want to increase the
processing speed. (Usually, select [HI-RESO] of the default values.)
Selecting the Measurement Object
Change it when you measure glass or mirrors. (Usually, select [NORMAL] of the default values.)
When you select Multi-Task mode, specify the setting for each task.
Setting the Scaling
You can correct the display value of the measured value as desired.
Setting HOLD
Set the hold conditions.
Setting the Zero Reset Function
Set zero reset.
Save the Settings Data
Save the data you have set.
ZS-HL
1-8
User's Manual
Single-Task
Make sure that you always save the data after you set it.
If you turn OFF the power without saving the data, all the settings data will be cleared.
Section2
INSTALLATION & CONNECTION
Turn ON the power.
Switching to Multi-Task Mode
Selecting Tasks
Setting for Measurement
of Characteristic Points
p.2-2
Multi-Task
p.5-4
p.5-5
p.5-8
p.5-6
p.5-9
p.5-24
p.5-14
p.5-18
p.5-22
p.5-29