Omron ZS-HL User Manual page 152

Section8
Sensor Head
• When used in regular reflection (ZS-LD130)
Measuring
center
• When used in regular reflection (ZS-LD200)
Measuring
center
• When used in regular reflection (ZS-LD350S)
• When you measure a workpiece with regular reflection, such as glass, the entire measuring range may
not be used.
• When ZS-LD350S is connected, even after the setting for [SETTING] is changed to [REGULAR], cor-
rection is not performed internally. When a workpiece with regular reflection is attached, make sure to
perform scaling and use the Sensor Controller.
Measuring
center
ZS-HL
8-14
User's Manual
10.4
128.5
Emission axis
Reception
axis
Reference surface
200
Emission
axis
Reception
axis
Reference
surface
349.4
Emission axis
Reception axis
58.4
49.8
8.4 59.2
52
7 59.7
53.5
Reference surface
(Unit: mm)
49.8
Mounting hole dimensions
(Unit: mm)
52 0.1
Mounting hole
dimensions
(Unit: mm)
49.8
Mounting hole dimensions