Starting And Exiting Smartmonitor Zs - Omron ZS-HL User Manual

Starting and Exiting SmartMonitor ZS

■ Start-up of SmartMonitor ZS
After installation is completed, start up SmartMonitor ZS by the following procedure.
1.
Make sure that the Sensor Controller is connected to the personal com-
puter.
2.
Turn the Sensor Controller ON and set it to the RUN mode.
3.
Select [Programs]-[OMRON]-[SmartMonitorZS] from the Windows [Start]
menu.
■ When the connection between the personal computer and
Sensor Controller cannot be established
Check the COM port No. assigned on the personal computer in Device Manager.
1.
Right-click [My Computer] on the Windows desktop and click [Properties].
2.
Click [Device Manager(D)] on the [Hardware] tab.
3.
Open [Port (COM/LPT)], and check which number COM in [OMRON Smart
Sensor USB COM] is set to.
4.
Set this COM port No. to the [Communication Settings] screen on Smart-
Monitor ZS.
If "OMRON Smart Sensor USB COM" is not recognized in Device Manager, re-install the USB driver
and reboot the personal computer.
■ Exiting SmartMonitor ZS
Exit SmartMonitor ZS by the following procedure.
1.
Select [File]-[Close] in the SmartMonitor ZS menu bar.
Section2
SmartMonitor ZS
ZS-HL
User's Manual
2-19