Omron ZS-HL User Manual page 89

FUN mode-[OUTPUT]-[SCALING]-[ON]-[AUTO]
1.
Set the sensing object in place, and enter the
desired setting to be used as the offset.
The current measured value is displayed on the
main display, and the offset value is displayed
on the sub-display.
2.
Press the SET Key to apply the setting.
3.
Set the decimal point to determine the effec-
tive digits.
The decimal point set here becomes the new deci-
mal point of the scaling setting.
The position of the decimal point on the display fol-
lows the "DOT" setting of the display setup in RUN
mode.
4.
Press the SET Key to apply the setting.
5.
Press the SET key without entering any
value for the second point.
6.
[Select [FORWARD] or [INVERS].
FORWARD: The larger the distance between the Sensor Head and the sensing object, the
INVERS : The larger the distance between the Sensor Head and the sensing object, the
Setting Output Processing of Sensing Information
larger the measured value displayed on the Sensor Controller.
smaller the measured value displayed on the Sensor Controller.
Section5
INPUT POINT 1
DIG VAL SET:OK
INPUT DOT POINT
DIG VAL SET:OK
INPUT POINT 2
DIG VAL SET:OK
CHANGE DIRECTION
1 FORWARD 2 INVERS
User's Manual
ZS-HL
5-15