Connecting Using A Usb Cable Connection Method; Connecting Using A Usb Cable; Setting The Communication Specifications - Omron ZS-HL User Manual

Section7

Connecting Using a USB Cable

Connecting Using a USB Cable
Connection Method
1.
Install the USB driver to a personal computer.
Installation is required only when USB is connected for the first time.
2.
Insert one end of the USB cable into the
USB connector of the controller.
3.
Insert one end of the USB cable into the
USB connector of the external device.

Setting the Communication Specifications

Set the communication specifications for the controller according to the communication
specifications for external devices.
FUN Mode-[SYSTEM]-[COM]
RS-232C
NODE (node No.)
ZS-HL
7-4
User's Manual
Installing the USB driver p.2-16
The USB cable is an accessory of the Sensor
Controller ZS-HLDC_1A. Attach ferrite cores
to both ends of the cable.
Ferrite core
Setting
LENGTH
PARITY
STOP (STOP BIT)
BAUDRAT
DELIMIT
The settings are ignored.
CR, LF, CR+LF (default: CR)
The settings are ignored.
Range