Omron ZS-HL User Manual page 204

Section9
Updating Firmware
A message indicating the start of update
appears.
8.
Check the contents of the message and
click the [OK] button.
Update of the firmware will start.
The progress status is displayed during the processing of update. Wait until the
message box indicating that the update has finished normally appears (it takes a
few minutes to complete the update).
9.
After update completes, the following
message appears. Follow the instruc-
tions on the screen and perform the
operations.
10.
After you check the message, click the [OK] button.
ZS-HL
9-18
User's Manual
If the message "the model is not the same"
appears when you click the [Start upgrade]
button, it means that the model of the con-
nected controller and the model information in
the specified file do not match. In this case, do
not perform update. The controller will break
down and will not start normally thereafter.
• An error may occur on the controller during update; however, please wait.
• If the progress bar stops while update is being performed, or update does not finish normally
even after 10 minutes, there is a possibility that update may have failed.
In this case, contact an OMRON sales representative about the firmware version before
update and the one in the write file.
To complete the update of firmware, you need to initialize the controller. If the controller could
not be initialized automatically from Warp Engine ZS, manually initialize it as described in
steps 3 and 4. If the controller is initialized automatically, steps 3 and 4 are not displayed.