Omron ZS-HL User Manual page 205

■ Setting the Connection Port
When the startup of Warp Engine ZS fails, the following screen is displayed after a
message appears.
1.
Select [Settings]-[Control Panel] from the [Start] menu in the personal com-
puter and double-click [System].
The [System Properties] screen is displayed.
2.
Click [Device Manager] on the [Hardware] tab.
The [Device Manager] screen is displayed.
3.
Open [Port COM/LPT], and check the COM number in [OMRON Smart Sen-
sor USB COM Drivers (WDM) (COMxx)].
The (COMxx) part indicates the connection port for the controller.
4.
Select the connection port for the controller in [COM Port] and click the
[Set] button.
Warp Engine ZS will start.
Section9
Updating Firmware
ZS-HL
User's Manual
9-19