Omron ZS-HL User Manual page 71

■ DIRECT IN
The threshold values can be set by directly inputting numerical values. Direct input is
useful when you know the dimensions for an OK judgment or when you want to fine-
tune threshold values after teaching.
The following describes the operation method using, as an example, the procedure for
setting the HIGH threshold value by directly entering it.
1.
Set the mode switch to TEACH.
2.
Switch the threshold switch to "H" to
set the HIGH threshold value.
3.
Enter the setting value you want to
change.
The current measured value is
displayed on the main display, and
the offset value is displayed on the
sub-display.
← → : Change the digit,
↑ ↓ : Change the value
4.
Press the SET key to apply the set-
ting.
If you want to cancel the threshold value
that is being changed, press the ESC
key.
Section4
Threshold Setting
TEACH
FUN RUN
ESC
MENU
1 2
3 4
TEACH SET
H L FUN RUN
H L
ESC
MENU
1 2
3 4
TEACH SET
H L FUN RUN
TEACHMODE
: DIRECT IN
TEACHMODE
: DIRECT IN
User's Manual
ZS-HL
4-9