Omron ZS-HL User Manual page 65

Details displayed on the sub-display
Display Details
THRESH
VOLTAGE (CURRENT)
RESOLU
BRIGHT
DISTANCE
TASK_ MEASURE
TERMINAL
JUDGMENT RESULT
MAIN: MEASURE
SUB: RESOLU
MAIN: MEASURE
SUB: TASK2 MEASURE
*3)
The display details vary according to the option for OUTPUT of TERMINAL BLOCK. It is not
displayed when you select [NONE] in [TERMINAL BLOCK]-[OUTPUT].
*4) JUDGEMENT RESULT is displayed for each TASK (P: PASS, E: ERROR, H: HIGH, L: LOW).
Switching the Display of the Measured Value
Displays the HIGH/LOW threshold values according to the setting of the threshold switch.
Displays the voltage (current) to be linearized. The display details change accord-
ing to the setting of the current/voltage switch. (Values displayed here are refer-
ence values only. These values differ from actual linear output values.)
Displays the fluctuation width (peak to peak) of the measured value over a fixed
amount of time.
Displays the current received light amount. The current emitted light amount also
is displayed on the LCD upper section. When you attach the Sensor Head, adjust
the position of the Sensor Head so that the emitted light amount is as small as
possible compared to the received light amount (1000).
Inside of the Sensor Controller, the emitted light amount is automatically adjusted
in the range from 0.1 % to 80 % so that the received light amount reaches 1000.
Even if the emitted light amount reaches the maximum 80 %, but the received light
amount is not close to 1000, change the settings to switch the measurement mode
to HI-SENS or to increase the gain to increase the received light amount.
Displays the distance from the Sensor Head to the workpiece.
In Multi-Task mode, this menu displays the measurement result for another TASK.
Displays the value that is output to ZS-RPD.
TK1
Description
LD POWER: 1.0%
SUB: BRIGHT
MAIN: MEASURE
SUB: DISTANCE
MAIN: MEASURE TK1
SUB: TASK1 MEASURE
Section4
(*1)
TK1
ZS-HL
4-3
User's Manual