Omron ZS-HL User Manual page 110

Section6
Settings for Linear Output
3.
Set the correction value for point 1.
The measured value is displayed on the sub-
display.
Adjust the correction value on the sub-display
so that the measured value of the ammeter (or
voltmeter) and the output value shown on the
main display are the same.
4.
Press the SET Key to apply the setting.
5.
Set point 2 in the same way as point 1.
ZS-HL
6-6
User's Manual
If the points are not set correctly, check to see if the
current (or voltage) values of points 1 and 2 are the
same.
INPUT POINT 1
DIG VAL SET:OK
INPUT POINT 2
DIG VAL SET:OK