Setting Hold Functions - Omron ZS-HL User Manual

Section5
Setting Output Processing of Sensing Information

Setting HOLD Functions

Set the hold conditions for measured values. The hold functions hold any value from the
measured values during the specific period (sampling period), such as the maximum or
minimum value.
■ TYPE
Set the hold conditions for measured values.
FUN Mode-[OUTPUT]-[HOLD]-[TYPE]
OFF
PEAK
BOTTOM
P-P
AVERAGE
ZS-HL
5-18
User's Manual
Setting
Hold measurement is not performed. The measured value is output at all
times. (default value)
Holds the maximum value during the sampling period. The output
changes at the end of the sampling period and is held until the end of the
next sampling period.
Current
measured value
Holds the minimum value during the sampling period. The output changes
at the end of the sampling period and is held until the end of the next sam-
pling period.
Current
measured value
Holds the difference between the maximum and minimum values during
the sampling period. This option is selected mainly when detecting vibra-
tion. The output changes at the end of the sampling period and is held
until the end of the next sampling period.
Current
measured value
Holds the average measured value during the sampling period. The out-
put changes at the end of the sampling period and is held until the end of
the next sampling period.
Current
measured value
Description
Max. value
Sampling period
Min.
value
Sampling period
Max. value
Min.
value
Sampling period
Sampling period
Output
Output
Output
(max. value - min.
value)
Output
(average)