Omron ZS-HL User Manual page 97

■ 0RESET MEMORY
You can select whether or not to hold the measured value zero reset level even if the
power is turned OFF.
FUN Mode-[SYSTEM]-[0RESET]
Setting
OFF
ON
Turn [OFF] zero reset memory if, as in the example below, the zero point is reset for
each measurement.
Example: When the step of the sensing object is measured
• If zero reset memory is [ON], the zero reset level data will be written in the Sensor Controller non-
volatile memory (EEPROM) at each zero reset. The EEPROM can be written a maximum of
100,000 times. Writing the zero reset level for each measurement can, therefore, use up the life of
the memory and lead to malfunctions.
• Even if zero reset memory is enabled, the zero reset level will be held also when it is saved. Zero
reset will continue after startup when these functions have been changed.
Setting Output Processing of Sensing Information
Zero reset is canceled when the power is turned OFF. (default value)
The zero reset level is saved to memory even if the power is turned OFF.
Sensor Head
This step
is mea-
sured.
Zero reset Zero reset
executed
executed
Direction of movement
Description
Zero reset
executed
Section5
ZS-HL
5-23
User's Manual