To assemble the inner source:
Warning:
To avoid personal contamination with biologically hazardous, toxic, or corrosive
materials, and to avoid spreading contamination to uncontaminated surfaces, wear clean,
chemical-resistant, powder-free gloves when performing this procedure.
1.
Fit the repeller and the repeller rod into the repeller holder.
Figure 4–18: Fitting the repeller components together
2.
Fit the repeller assembly into the inner source.
Figure 4–19: Fitting the repeller assembly
3.
Lower the ionization chamber onto the repeller assembly.
April 27, 2020, 715005564 Ver. 01 (previously released as Rev. A)
Page 71