Table of Contents
Advertisement
Clamp
Shield
Connection cover
5.
Insert the connector with the signal cable into the connection cover, and position the clamp
over the cable leads. Tighten the clamp into place with the second self-tapping screw.
Figure B–11: Securing the cable leads
Clamp
Cable leads
6.
Place the second connection cover over the first cover, and snap it into place.
Figure B–12: Fitting the connector cover
Signal connector
Connector cover
April 27, 2020, 715005564 Ver. 01 (previously released as Rev. A)
Page 135
Advertisement
Table of Contents
