Table of Contents
Advertisement
Figure 5-10: Dual RS-232 Cable Installation
Step 3:
Secure the bracket. The dual RS-232 connector has two D-sub 9 male
connectors secured on a bracket. To secure the bracket to the chassis please
refer to the reference material that came with the chassis.
5.7.6 SATA Drive Connection
The SPCIE-3600AM2 is shipped with two SATA drive cables and one SATA drive power
cable. To connect the SATA drives to the connectors, please follow the steps below.
Step 1:
Locate the connectors. The locations of the SATA drive connectors are shown in
Chapter 3.
Step 2:
Insert the cable connector. Press the clip on the connector at the end of the
SATA cable and insert the cable connector into the on-board SATA drive
connector. See Figure 5-11.
Page 84
SPCIE-3600AM2 PICMG 1.3 CPU Card
Step 0:
Advertisement
Table of Contents
