Table of Contents
Advertisement
5.7.7 USB Cable (Dual Port)
The SPCIE-3600AM2 is shipped with a dual port USB 2.0 cable. To connect the USB
cable connector, please follow the steps below.
Step 1:
Locate the connectors. The locations of the USB connectors are shown in
Chapter 3.
WARNING:
If the USB pins are not properly aligned, the USB device can burn out.
Step 2:
Align the connectors. The cable has two connectors. Correctly align pin 1on
each cable connector with pin 1 on the SPCIE-3600AM2 USB connector.
Step 3:
Insert the cable connectors. Once the cable connectors are properly aligned
with the USB connectors on the SPCIE-3600AM2, connect the cable connectors
to the on-board connectors. See Figure 5-13.
Figure 5-13: Dual USB Cable Connection
Step 4:
Attach the bracket to the chassis. The USB 2.0 connectors are attached to a
Page 86
SPCIE-3600AM2 PICMG 1.3 CPU Card
Advertisement
Table of Contents
