Sata Drive Connection; Figure 4-11: Backlight Inverter Connection - IEI Technology PM-PV-N4551/D5251 User Manual

PM-PV-N4551/D5251 User Manual
Step 4: Connect backlight connector. Connect the backlight connector to the driver
TFT LCD PCB as shown in Figure 4-11. When inserting the cable connector,
make sure the pins are properly aligned.

Figure 4-11: Backlight Inverter Connection

4.8.3 SATA Drive Connection

The PM-PV-N4551/D5251 is shipped with one SATA drive cable. To connect the SATA
drive to the connector, please follow the steps below.
Step 1: Locate the connector. The location of the SATA drive connector is shown in
Chapter 3.
Step 2: Insert the cable connector. Insert the cable connector into the on-board SATA
drive connector until it clips into place. See Figure 4-12.
Page 51