Table of Contents
Advertisement
Figure 4-12: Audio Kit Cable Connection
Step 3:
Connect the audio devices. Connect speakers to the line-out audio jack.
Connect the output of an audio device to the line-in audio jack. Connect a
microphone to the mic-in audio
4.7.3 SATA Drive Connection
The NANO-QM770 is shipped with two SATA drive cable. To connect the SATA drive to
the connector, please follow the steps below.
Step 1:
Locate the SATA connector and the SATA power connector. The locations of
the connectors are shown in Chapter 3.
Step 2:
Insert the cable connector. Insert the cable connector into the on-board SATA
drive connector and the SATA power connector. See Figure 4-13.
Page 54
NANO-QM770 EPIC SBC
jack.Step 0:
Advertisement
Table of Contents
