External Peripheral Interface Connection; Lan Connection (Single Connector) - IEI Technology SPCIE-3600AM2 User Manual
Full-size amd socket am2 picmg 1.3 cpu card supports opteron, athlon 64 x2, athlon 64 and sempron processors, 28 pcie expansion lanes, dual gbe, six sata 2.0, ten usb 2.0 and crt output
Table of Contents
Advertisement
SPCIE-3600AM2 PICMG 1.3 CPU Card
bracket. To secure the bracket to the chassis please refer to the installation
instructions that came with the
5.8 External Peripheral Interface Connection
The following external peripheral devices can be connected to the external peripheral
interface connectors.
RJ-45 Ethernet cable connectors
USB devices
VGA connector
To install these devices, connect the corresponding cable connector from the actual
device to the corresponding SPCIE-3600AM2 external peripheral interface connector
making sure the pins are properly aligned.
5.8.1 LAN Connection (Single Connector)
There are two external RJ-45 LAN connectors. The RJ-45 connectors enable connection
to an external network. To connect a LAN cable with an RJ-45 connector, please follow
the instructions below.
Step 1:
Locate the RJ-45 connectors. The locations of the USB connectors are shown in
Chapter 4.
Step 2:
Align the connectors. Align the RJ-45 connector on the LAN cable with one of
the RJ-45 connectors on the SPCIE-3600AM2. See Figure 5-14.
chassis.Step 0:
Page 87
Advertisement
Table of Contents
