Sata Drive Connection; Figure 4-21: Single Rs-232 Cable Installation - IEI Technology WAFER-ULT5 Manual

Hide thumbs Also See for WAFER-ULT5:

Table of Contents

WAFER-ULT5 SBC

Step 2:

Insert the cable connector. Align the cable connector with the onboard

connector. Make sure pin 1 on the board and connector line up. Pin 1 on the

cable connector is indicated with a white dot. See Figure 4-16.

Figure 4-16: Single RS-232 Cable Installation

Step 3:

Secure the bracket. The single RS-232 connector has two retention screws

that must be secured to a chassis or bracket.

Step 4:

Connect the serial device. Once the single RS-232 connector is connected to

a chassis or bracket, a serial communications device can be connected to the

system.

Step 0:

4.8.4 SATA Drive Connection

The WAFER-ULT5 is shipped with a SATA drive cable. To connect the SATA drive to the

connector, please follow the steps below.

Step 1:

Locate the SATA connector and the SATA power connector. The locations of

the connectors are shown in Chapter 3.

Step 2:

Insert the cable connector. Insert the cable connector into the on-board SATA

drive connector and the SATA power connector. See Figure 4-17.

Page 57

Table of Contents