Jumper Settings; Clear Cmos Jumper; Table 5-1: Jumpers - IEI Technology SPCIE-3600AM2 User Manual

SPCIE-3600AM2 PICMG 1.3 CPU Card

5.5 Jumper Settings

NOTE:
A jumper is a metal bridge that is used to
close an electrical circuit. It consists of
two metal pins and a small metal clip
(often protected by a plastic cover) that
slides over the pins to connect them.
To CLOSE/SHORT a jumper means
connecting the pins of the jumper with
the plastic clip and to OPEN a jumper
means removing the plastic clip from a
jumper.
Before the SPCIE-3600AM2 is installed in the system, the jumpers must be set in
accordance with the desired configuration. The jumpers on the SPCIE-3600AM2 are listed
in Table 5-1.
Description
Clear CMOS

Table 5-1: Jumpers

5.5.1 Clear CMOS Jumper

Jumper Label:
Jumper Type:
Jumper Settings:
Jumper Location:
If the SPCIE-3600AM2 fails to boot due to improper BIOS settings, the clear CMOS
jumper clears the CMOS data and resets the system BIOS information. To do this, use the
Jumper
Label Type
J_CMOS1 3-pin header
J_CMOS1
3-pin header
See Table 5-2
See Figure 5-5
Page 75