Table of Contents
Advertisement
gKINO-V/R1000 SBC
4.6 Chassis Installation
4.6.1 Airflow
WARNING:
Airflow is critical for keeping components within recommended
operating temperatures. The chassis should have fans and vents as
necessary to keep things cool.
The gKINO-V/R1000 must be installed in a chassis with ventilation holes on the sides
allowing airflow to travel through the heat sink surface. In a system with an individual
power supply unit, the cooling fan of a power supply can also help generate airflow
through the board surface.
4.6.2 Motherboard Installation
To install the gKINO-V/R1000 motherboard into the chassis please refer to the reference
material that came with the chassis.
4.7 SATA Drive Connection
The gKINO-V/R1000 is shipped with a SATA drive cable. To connect the SATA drive to
the connector, please follow the steps below.
Step 1:
Locate the SATA connector and the SATA power connector. The locations of
the connectors are shown in Chapter 3.
Step 2:
Insert the cable connector. Insert the cable connector into the on-board SATA
drive connector and the SATA power connector. See Figure 4-7.
Page 57
Advertisement
Table of Contents
