Table of Contents
Advertisement
WSB-9152 PICMG 1.0 SBC
Figure 5-18: Dual RS-232 Cable Installation
Step 3:
Secure the bracket. The dual RS-232 connector has two D-sub 9 male
connectors secured on a bracket. To secure the bracket to the chassis please
refer to the reference material that came with the
5.6.8 SATA Drive Connection
The WSB-9152 is shipped with two SATA drive cables and one SATA drive power cable.
To connect the SATA drives to the connectors, please follow the steps below.
Step 1:
Locate the connectors. The locations of the SATA drive connectors are shown
in Chapter 3.
Step 2:
Insert the cable connector. Press the clip on the connector at the end of the
SATA cable and insert the cable connector into the onboard SATA drive
connector. See Figure 5-19.
chassis.Step 0:
Page 95
Hide quick links:
Advertisement
Table of Contents
