Table of Contents
Advertisement
Step 4:
Figure 5-6: IDE Cable Connection
Step 5:
Connect the cable to an IDE device. Connect the two connectors on the other
side of the cable to one or two IDE devices. Make sure that pin 1 on the cable
corresponds to pin 1 on the
5.7.3 Audio Kit Installation
An optional audio kit that is separately ordered connects to the 9-pin audio connector on
the SPCIE-3600AM2. The audio kit consists of five audio jacks. One audio jack, Mic In,
connects to a microphone. The remaining four audio jacks, Front-In, Front-Out, Rear-Out
and subwoofer connect to four speakers including a subwoofer. To install the audio kit,
please refer to the steps below:
Step 1:
Locate the audio connector. The location of the 10-pin audio connector is shown
in Chapter 3.
Step 2:
Align pin 1. Align pin 1 on the on-board connector with pin 1 on the audio kit
Page 80
SPCIE-3600AM2 PICMG 1.3 CPU Card
connectorStep 0:
Advertisement
Table of Contents
