TOHATSU MFS 8B Service Manual page 76

19. Secure remote control stay cover with screws.
Shift gear from neutral (N) to forward (F), neutral (N),
and then to reverse (R) to check that shift operation is
performed smoothly. Adjust shift link rod length and shift
cable position if necessary.
1. Shift gear into neutral (N).
2. Remove shift link rod
3. Check and adjust standard length
Remote Control Model
74 mm (2.91 in)
4. Perform shift adjustment after assembling lower unit.
Loosen shift lever stopper bolt
ass'y fully to forward, adjust shift lever stopper
position, and then, tighten shift lever stopper bolt
Operate shift lever to check that operation from neutral (N)
to forward (F) to neutral (N) to reverse (R) is normal, and
forward and reverse movements are equal to each other.
3-26
.
of shift link rod.
:
. Set shift lever shaft
N N
R R
.
F F
4st 8/9.8 2016