TOHATSU MFS 8B Service Manual page 157

8. Attach sensor wire to oil pressure sensor, and install
grommet .
· When installing grommet, be careful not to
plug small hole
· Direct ground wire to Bow side.
9. Use clamp bolt to secure ground wire from ignition coil.
10. Use crank case bolt to secure main harness ground wires
(black and light green) and rectifier ground wire.
For MF model, use crank case bolt to secure
only main harness ground wires (black and light
green).
11. Connect CD unit lead wire (orange) with ignition coil lead
wire (orange), bundle the wires with sensor wire from oil
pressure switch and cords from alternator, and secure them
using clamp.
1. Attach starter cord to starter motor as shown, and then,
terminal cap to starter cord.
4st 8/9.8 2016
of switch with grease.
5-53