TOHATSU MFS 8B Service Manual page 141

2. Secure oil pump using three M6 bolts by tightening them to
specified torque in the order specified below.
Order of tightening :
1
Oil Pump Bolts :
First tightening torque: 4 N · m (3 lb · ft) [0.4 kg · m]
Second Tightening Torque : 9 N · m (7 lb · ft) [0.9 kg · m]
· Degrease mating surfaces of cylinder head
and cylinder block.
· No.1 piston is to be at top dead center of
compression stroke.
1. After installing cam shaft pulley, bring "●1" mark
to "▲" mark of cylinder head.
2. Check that "▲" mark
of cylinder block are aligned with each other.
No.1 piston is to be at top dead center.
3. Before installing cylinder head, fill oil passages and oil pump
again with engine oil as shown.
4st 8/9.8 2016
→ →
2 3
of pulley
of timing pulley and "▲" mark
1
3
2
2mL
2
5-37