TOHATSU MFS 8B Service Manual page 154

1. Install exhaust cover
gasket and thermostat cover
· For air bleeding, install the part with concave
of valve facing upward.
· When reusing thermostat, check the part by
referring to Chapter 3.
2. Install new gasket, anode
Apply thin coat gasket with grease before
attaching it.
3. Install oil pressure switch
· Before installing oil pressure switch, coat the
thread with ThreeBond 1342.
· Use socket wrench of which width between
two parallel faces is 24mm.
Oil Pressure Switch:
8 N · m (6 lb · ft) [0.8 kgf · m]
4. Install cylinder head and cylinder head cover
For installation procedure, refer to "Chapter 5
Installation of Cylinder Head".
5-50
, and then install thermostat
.
and anode cap .
, and tighten to specified torque.
.
, new
4st 8/9.8 2016