TOHATSU MFS 8B Service Manual page 180

2. Use commercially available universal puller plate to remove
ball bearing.
Before removing, check bearing for play or
deflection. Replace if necessary.
3. When removing only oil seal, use bladed screw driver to pry
apart.
1. Use cleaning oil and cleaning brush to clean propeller
shaft housing, and check it for crack or damage. Replace if
necessary.
2. Check reverse (C) gear teeth and clutch for crack or
damage. Replace if necessary.
3. When reusing bearing without removing it, check it for play
or deflection. Replace if necessary.
1. Apply engine oil to periphery of new oil seal, and install into
propeller shaft housing with number side facing upward by
using proper mandrel.
Apply lithium grease to lip of oil seal after installing it.
6-14
Oil seal
Do not reuse.
4st 8/9.8 2016