TOHATSU MFS 8B Service Manual page 261

Inspection of UP side relay
4. As shown in the figure, connect blue terminal (L) in the
coupler to battery positive terminal and black terminal (B) to
negative terminal, and then, connect circuit tester leads to
PT relay terminals and
5. Check electrical conductivity between terminals
Replace relay if non-conductive.
Inspection of DOWN side relay
6. As shown in the figure, connect green terminal (G) in the
coupler to battery positive terminal and black terminal (B) to
negative terminal, and then, connect circuit tester leads to
PT relay terminals and
7. Check electrical conductivity between terminals
Replace relay if non-conductive.
)
1. Check electrical conductivity of PT switch. Replace if out of
specification.
Lead Wires
Switch Position Sky Blue (Sb)
UP (Tilt Up)
Free
DOWN (Tilt Down)
1. Check electrical conductivity of fuse
conductivity.
Flat or small sized plate fuse (20A) is adopted.
4st 8/9.8 2016
.
and
.
and
Red (R) Pink (P)
and ' and '
. Replace if no
.
.
8-17