TOHATSU MFS 8B Service Manual page 178

1. Apply gear oil to periphery of new oil seal, and install into
pump case (lower) with number side facing downward.
2. Apply LITHIUM grease to lip of oil seal.
1. Remove propeller shaft ass'y.
Use a plastic hammer to remove the part if it
cannot be removed by inserting a bladed screw
driver.
2. Use commercially available puller to remove.
1. Fix propeller shaft ass'y with vice, remove push rod
spring retainer first, and then, drive out spring pin
remove clutch and spring
• While driving out spring pin, be careful not to
let spring pop out.
• Use spring pin tool A.
• Do not reuse removed spring pin.
Spring Pin Tool A (ø3.5) :
P/N. 369-72227-0
2. Check clutch , spring retainer
crack and wear. Replace if necessary.
6-12
and
and
.
, ball, and push rod for
4st 8/9.8 2016