TOHATSU MFS 8B Service Manual page 73

4. Set remote control lever to full open position.
5. Contact throttle drum
then bring remote control cable end nut
cable joint .
6. Screw on cable joint
nut.
7. Fit cable joint into throttle drum
control lever to full open position to check that throttle
drum contacts full open stopper
Tighten cable joint nut
and snap pin .
8. With carburetor throttle lever
stopper , push throttle rod
secure it by using screw
4st 8/9.8 2016
with full open stopper
to position of
to position of remote control cable
, and set remote
.
and secure by using washer
pushed against full open
toward throttle drum, and
.
, and
3-23